The solution to the unstable labeling position of the labeling machine:

1. The belt pressing device may not be pressed tightly, resulting in loosening of the standard belt and inaccurate detection by the electric eye;

2. The traction mechanism may be slipping or not being pressed tightly, resulting in the inability to remove the bottom paper smoothly, resulting in different lengths of the bid;

3. The marking speed and the conveying speed do not match;

4. The inclination of the press-marking brush at the label stripping board is not suitable. When the label is sent out, the label should be close to the brush to make the label sending out angle consistent.

The labeling machine has poor labeling quality, bubbles or wrinkles. Solution:

1. The labeling wheel may not be parallel to the surface to be laminated, just adjust the labeling wheel;

2. The delivery speed, delivery speed, and overriding speed are not matched. Most of the delivery speeds are too fast. Re-adjust the delivery speed or delivery speed;

3. The label strength is not enough, and it is easy to wrinkle during the labeling or overwriting process.

The solution of labeling machine deviation during the labeling process:

1. The belt pressing device is too tight, which causes the standard belt to be biased, so the pressing force can be reduced;

2. The tape has not been corrected before the automatic operation, and the correction can be performed again;

3. The standard stripping board is skewed and the standard strip is misaligned, so you only need to adjust the stripping board.

The above is the relevant content of the labeling machine, I hope it will be helpful to everyone.

* Name：

* Phone number：

Mailbox：

* Message content：

* Verification code：

Change one