How to maintain the shrink packaging machine regularly!

Many parts of the shrink packaging machine need regular maintenance during the use process, so which parts of the shrink packaging machine need regular maintenance? Next, the Henan automatic packaging machine manufacturer will tell you the details of how the shrink packaging machine should be maintained regularly!

1. We must check some mechanical parts regularly, such as once every half a month or once a month. The inspection parts include: worm gear, worm, bolts on the lubrication block, bearings and other movable parts to see if these parts are flexible in rotation and wear , If defects are found, they should be repaired in time and should not be used reluctantly.

Second, the heat shrinking machine should be used in a dry and clean room, and it should not be used in a place where the atmosphere contains acids and other gases that are corrosive to the body.

3. After the heat shrinking machine is used, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it, ready for the next use.

4. If the roller moves back and forth during work, please adjust the M10 screw on the front bearing to the proper position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the proper position, adjust the gap so that the bearing does not make a noise, and the hand-turned pulley is properly tight. Too tight or too loose can cause damage to the machine.

5. If the packaging machine equipment is not used for a long time, the whole body of the machine must be cleaned, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth hood. If the device has not been used for a long time, you must check whether all parts are normal before using it.